RE: AUTO PLANT-WORK AREA INSERTION POINT
Hello CADTech,I see you have multiple selections, could try to select one reference drawing at a time and change the insertion point to see if it works?RegardsDinesh Solanki
View ArticleAutoplant Valve Topworks Orientation in Isogen
Hi, When I produce an isometric with a valve in the line the valve topworks are shown but there is no note to say what is the topworks orientation (North, South, East, West, Up, Down etc). When I have...
View ArticleRE: Open Plant Model Server reference out piping with VBA
The first thing I would try if getting this error message would be restarting the modelserver service
View ArticleI-model export - Level state on/off
HI,I'm using Openplant modeller to export I-model so we can review in Navigator.The problem is when exporting I-model from OPM model all levels are on but after exported I-model open in a Navigator...
View ArticleRE: Open Plant Model Server reference out piping with VBA
So in this case it does seem that most likely issue of not being able to reference out by System is due to some issues in your Workspace configuration. As you have added some additional associated...
View ArticleRE: AUTO PLANT-WORK AREA INSERTION POINT
The issue with the xref. was in using relative paths, having the relative path box checked. The xref worked after un-checking that box. As far as insertion point, I could set and pick on screen but...
View ArticleRE: AUTO PLANT-UNITS SETTING
Dinesh,I noticed a lot of my files are set to Architectural unit type and Inches for units. I typically work in Decimal unit type/Feet and the scale pull-down I have set to unitless. I do not recall...
View ArticleRE: AUTO PLANT-EQUIPMENT PLACEMENT
Dinesh,Ok, so if I want to change the name of a Location Point, it looks like I must delete the point and make a new point reflecting the new name?
View ArticleRE: AUTO PLANT-WORK AREA
Dinesh,You are correct, when I make the reference path "full" instead of "relative", I get the complete path.
View ArticleRE: AUTO PLANT-EQUIPMENT "BASE" POINT
Dinesh,Still not getting any change in elevation of my pump after changing the elevation of the location point. Maybe my location point is not associated with the pump. If I wanted to establish a new...
View ArticleRE: AUTO PLANT-EQUIPMENT COORDINATE
Dinesh,I used the foot mark but still no change in equipment location. Is there a way to test if a location point is properly associated with an equipment?
View ArticleRE: AUTO PLANT-EQUIPMENT LOCATION
Is the Master Node the base point for placing equipment?
View ArticleRE: AUTO PLANT-EQUIPMENT LOCATION
I am sorry If I have misunderstood your question. if you mean switching ON Master node from the Technote...
View ArticleRE: AUTO PLANT-EQUIPMENT COORDINATE
Hello CADTech,Please try giving higher values to see if it changes. Also, try changing the co-ordinates as well. Co-ordinates and elevation could be checked using AutoCAD command ID for...
View ArticleRE: AUTO PLANT-EQUIPMENT "BASE" POINT
If you mean switching ON Master node from the Technote below: communities.bentley.com/.../4271.how-to-hide-nodes-for-components-that-appear-out-in-space-tn.aspxThe command for equipment is...
View ArticleClik here to view.
Troubles with flattener
Hello.I have some trouble with flat my DWG files - lost piping lines.Screen before flat (source DWG, after purge, audit, bind xref)Screen after flat (flat file)What are the reasons?
View Article