PSDS XM v08.09.04.52 Nov 2009
Otion Switch 71 (PLOTFILE / BACKING SHEET FORMAT)
If I run IsoGen with output format set to .DXF (ASCI) I get a good output.
If I change the output format to Smart DWG, I get an output, but if I try to open the file, AutoCAD says: Drawing file is not valid.
Alias.mes says:
***** POD Error(s) ***** Unable to load XML document : R:\15-PSDS\PISOGEN\FINAL\DRAWINGS\Test-5.XML Error Code : 800c0007, Description : No data is available for the requested resource.
Line/Position : 0/0
Any suggestions?