Hi,
Just to follow up from a previous discussion about cross model connectivity, it happened mid-post from this thread:
Just a summary, I've got line A in A.dgn and line B in B.dgn.
In B.dgn, line A is referenced as an attachment, and line B was connected to referenced line A.
Below is what I got when run the continuity check on open ends of line B. Line B is on the right. Referenced Line A is highlighted on the left.
In A.dgn, I referenced B.dgn in, then perform a continuity check, and below is what I get:
So continuation only exists on line B and not on line A, which leads to missing continuation symbology in line A's isometric drawings.
Is there anyway to fix this? I would expect connections to exist in both pipelines, not just one.
Best regards,
Tuan Le