In OPIM, when a valve operator is rotated, the angle of the operator is called out as Up or Down, with the angle of the operator.
Is there a setting to ignore this label below a certain number of degrees?
On one of our projects, we have sloped pipe with valves and hand wheels shown. The program sees the operators as angled and puts the label "HAND_WHEEL, E 1 DOWN" at the operators. The hand wheels aren't rotated 1 degree.
I'd like to tell the program to not add a label for any operator sloped less than five or ten degrees. Is there an Exclude rule I could add to the Operator label in OPIM?